Rooting media for hoya cuttings: perlite, peat, sand, sphagnum or water

Published 3 October 2026Not yet reviewed by the editor7 sources

Short answer

A rooting medium should be sterile, low in nutrients, well drained and still moisture-retentive [1]. Proven mixes include one part peat to one or two parts perlite, peat and sand in equal parts, coarse sand alone, or a commercial potting mix [1]; the RHS uses peat-free cuttings compost for hoyas [5]. Avoid garden soil and compost, and do not use vermiculite on its own [2, 1].

What the medium is for

A cutting has no roots yet, so the medium does not need to feed it. Illinois Extension calls rooting media inert: their job is to hold the cutting in place, and they should be watered without being oversaturated, because a medium that stays too moist can cause rot [3]. NC State’s Extension Gardener Handbook lists the properties that matter: the medium should be sterile, low in fertility, well drained enough to let air in, and moisture-retentive enough that it does not need watering too often [1]. Penn State adds that light, clean materials let roots develop in a moist environment free of pathogens [2].

The common materials

Penn State describes the materials most often used for houseplant cuttings [2]:

Material What Penn State says
Water Can be used for leaves, stem tips and stem sections
Sand Good drainage and aeration; acidic pH (6.5 or lower is preferred for cuttings)
Vermiculite Holds water well; neutral pH
Perlite Good drainage and aeration; neutral pH
Bark Very good drainage and aeration; acidic pH

These can be used alone or combined [2].

  • Peat and perlite, one part peat to one or two parts perlite by volume [1].
  • Peat and sand, equal parts by volume [1].
  • Coarse sand alone, or pine bark [1].
  • A commercial potting mix; NC State notes that various commercial mixes can be used [1], and Illinois Extension suggests a soil-free potting mix, perlite or vermiculite [3].
  • Peat-free cuttings compost, which is what the RHS uses for layering hoyas and for potting up hoya cuttings rooted in water [5]. In its general guide to semi-ripe cuttings, the RHS makes cuttings compost from equal parts free-draining peat-free potting compost and sharp sand [6].

If you prefer to avoid peat, the RHS peat-free options fit, and Penn State notes that the materials in the table can be used alone [2], perlite included.

What to avoid

  • Garden soil and compost. Penn State says they are likely to contain pathogens and weed seeds and tend to be heavy and poorly aerated [2].
  • Vermiculite on its own. NC State does not recommend it, because it packs down and holds too much moisture [1]. Mixed with other materials it is fine [2].
  • A soggy medium. Rot is the main risk at this stage [3].

Preparing the medium

Moisten the medium before inserting the cuttings [1, 4]. Illinois Extension suggests making the planting hole with a pencil [4]; NC State’s handbook recommends the same kind of tool (a dibble) when cuttings have been dipped in rooting powder, so the powder stays on [1]. Use a container with drainage holes and keep it humid with a clear cover (see stem cuttings).

Water and sphagnum

Water is a rooting medium in its own right [2]; the RHS describes rooting hoya cuttings in a glass of water [5]. Illinois Extension cautions that water-rooted cuttings of many houseplants have weak roots that may struggle after potting [3]. The comparison is covered in water or mix.

Sphagnum moss appears in the sources as the medium for air layering, wrapped around a wounded stem: NC State uses damp, unmilled sphagnum [1], and Texas A&M advises soaking it for several hours and squeezing out the surplus, because excess moisture causes decay [7]. See the layering guide. We found no institutional guidance for rooting hoya cuttings directly in sphagnum.

After rooting

A rooting medium is not a long-term home: it is low in nutrients by design [1]. Once the cuttings have rooted, move them into a free-draining potting mix (see potting up and the potting mix guide).

Questions

Can I root hoya cuttings in sphagnum moss?

The sources we checked mention sphagnum only for air layering, where damp sphagnum is wrapped around a wounded stem [1, 7]. We found no institutional guidance on rooting hoya cuttings in sphagnum, so we do not give a method for it here.

Should I add fertilizer to the rooting mix?

No. NC State's handbook says the medium should be low in fertility [1], and Illinois Extension describes the medium's job as simply holding the cutting in place [3].

Species mentioned

Related guides

Sources

  1. Propagation, Chapter 13, North Carolina Extension Gardener Handbook (LeBude & Blazich, 2022). NC State Extension. Properties of a rooting medium; recommended mixes; vermiculite alone not recommended; sphagnum for air layering. Accessed 1 October 2026.
  2. Propagating Houseplants. Penn State Extension. Properties of water, sand, vermiculite, perlite and bark; avoid compost and garden soil. Accessed 1 October 2026.
  3. Winter gardening: propagating houseplants to beat the winter blues (Good Growing blog, 21 February 2025). University of Illinois Extension. Inert media; perlite, vermiculite, soil-free mix; oversaturation causes rot; water-rooted roots. Accessed 1 October 2026.
  4. Cuttings (Houseplants). University of Illinois Extension. Pre-moistening the medium. Accessed 1 October 2026.
  5. How to grow hoya. Royal Horticultural Society. Peat-free cuttings compost for hoya layering and for potting water-rooted cuttings. Accessed 30 September 2026.
  6. Semi-ripe cuttings. Royal Horticultural Society. Cuttings compost of peat-free potting compost and sharp sand, half and half. Accessed 1 October 2026.
  7. Air Layering for Difficult-to-Root Plants. Texas A&M AgriLife Extension, Earth-Kind Landscaping. Soaking and squeezing sphagnum; excess moisture causes decay. Accessed 1 October 2026.